I'm no sparky but you do look close.
Don't give up. Go through each and every connection again. Look for a place where a missing cable might go.
Something could just be backwards.
All it takes is one wire being pinched or loose.
Good luck I hope you have success.
Reconnecting Trademark LCD screen tutorial
Moderator: Moderators
The Forest the future site of North America's largest Pachislo Museum
http://www.pachislodb.com/index.php?ind ... lor=Forest
http://www.pachislodb.com/index.php?ind ... lor=Forest
Spiderman 2 LCD
So I've taken it all apart, checked all connections. I think the connection from the lcd screen might be broken (it looks like there is a very deep bend in it). Does anyone know where I can get a new screen?
- Attachments
-
- lcd1.JPG (19.77 KiB) Viewed 21309 times
-
- lcd3.JPG (20.78 KiB) Viewed 21309 times
-
- lcd4.JPG (16.7 KiB) Viewed 21309 times
lcd serial number
here's a picture of the serial number
- Attachments
-
- lcd5.JPG (18.4 KiB) Viewed 21308 times
Not sure if the bend in ribbon is the culprit.
But it would be a good if you could switch it out.
Does anybody know of a company that may sell them?
If you can take some pic's of the connectors,some good measurements or get a model # off the ribbon I bet that it can be found.
Don't give up someone here may come along with help.
But it would be a good if you could switch it out.
Does anybody know of a company that may sell them?
If you can take some pic's of the connectors,some good measurements or get a model # off the ribbon I bet that it can be found.
Don't give up someone here may come along with help.
The Forest the future site of North America's largest Pachislo Museum
http://www.pachislodb.com/index.php?ind ... lor=Forest
http://www.pachislodb.com/index.php?ind ... lor=Forest
Re: Reconnecting Trademark LCD screen tutorial
How did this story end??? I may have a similar situation here in 2017.
-
- Member
- Posts: 24
- Joined: Fri Jul 22, 2016 6:10 am
- Has thanked: 1 time
Re: Reconnecting Trademark LCD screen tutorial
I'm looking at the photo's on making the connections and on #5 I do not see a ribbon connected on the top of the card as on my spiderman2.
Spiderman2 should have the copper ribbon on the bottom of the card and a wide "wire type" ribbon going into the top of the card.
The photo's of your copper ribbon, it appears to be in much better shape than many. I have2 Sammy and 2 rodeo where the ribbon was cut with scissors.
Hope this helps solve your problem
Gene
Spiderman2 should have the copper ribbon on the bottom of the card and a wide "wire type" ribbon going into the top of the card.
The photo's of your copper ribbon, it appears to be in much better shape than many. I have2 Sammy and 2 rodeo where the ribbon was cut with scissors.
Hope this helps solve your problem
Gene
-
- Member
- Posts: 1
- Joined: Mon Feb 07, 2022 6:07 pm
Re: Reconnecting Trademark LCD screen tutorial
I have a rodeo machine that has funky Vegas decals on it . Just fyi they come apart the same, I just took mine apart after finding out it is a ore no sora . The screen ribbon has been clipped does anyone know where or if there is a place to get a replacement. Heck I would be happy with any screen that wasn't that darn Vegas sticker. Thanks